Skip to content
English
  • There are no suggestions because the search field is empty.

Set and Unset WAN Commands via CLI

Learn how to configure a static WAN IP address or set dynamic host addressing (DHCP) on a Neeve node using command-line interface commands via SSH.

Before connecting, ensure you have the following:

  • An Ethernet cable connected from your laptop to the LAN B (Management) Port on the node.
  • Your laptop's IP address configured within the same subnet range as the management port (192.168.192.x).
  • The private SSH key saved on your local machine.

Step 1: Connect to the Node via SSH

  1. Open your terminal or command prompt.
  2. Navigate to the directory containing your SSH key or provide the full file path.
  3. Run the following command to log in:ssh -i /path/to/<private-key>.pem iotium@192.168.192.168

Set Static WAN IP

 To configure a static IP address for the WAN interface, enter the WAN configuration mode and apply your network settings: 

set wan
(set wan) > ip --addr <IP-ADDR> --netmask <NETMASK> --gateway <GATEWAY>
(set wan) > save
(set wan) > exit

Unset WAN / Enable DHCP  

To revert to Dynamic Host Configuration Protocol (DHCP) for dynamic IP assignment: 

unset wan
(unset wan) >
(unset wan) > ip
(unset wan) > save
(unset wan) > exit

 After applying the WAN configuration changes, verify that the new settings have taken effect by running the command below: 

show interface

Sample snap